Have you ever wanted to use a furniture spray gun for DIY makeovers? But you're unsure of which one to pick or how to use one?
Or are there times when you crave the speed and superior finish of a spray gun?
Well say no more! Aristospray expert Daryl explains how to use a furniture spray gun to achieve a flawless finish. The best part is that with the Gravity Gun from Aristospray, spray painting has never been easier!

Read on for a step by step instruction or check out our detailed video below!
The Equipment You Will Need
The QTech5 HVLP 5 Stage Turbine
The QTech5 HVLP 5 Stage Turbine pushes air up through the hose at a low pressure.
However, if you are not using the thicker paints, and you are spraying for stains and lacquers, then opt for the 3 stage turbine.
9.5 x 2.5 metre Hose (included in HVLP Turbine Spray Kit)
This is an air hose that isn't intended for the paint. Because only air flows through the hose, you can use it to clean surfaces as it blows off dust and dirt.
Two Types Of Spray Guns
Type 1: Suction Gun
This spray gun acts as a 1L pressure pot. It is a sealed unit, with a one-way check valve.
When the air flows through the machine, it pushes the air into the pressure pot and out the front of the machine. It forces high volumes of paint up the gun at a low pressure, which is why it's called HVLP.
Type 2: Gravity Gun
This spray gun is also a sealed unit and it acts like the suction gun except that the pressure pot is on the bottom. Another difference is that it is a 600 mL pot, which is 400 mL smaller than the suction gun.
However, it is easier to get underneath things when using the gravity gun. People use the gravity gun for stains, lacquers and two packs, and it picks up the last drop.
In this video, we are using the gravity gun.
Paint
We are using Taubmans Ultimate Enamel, which I highly recommend because it has the durability of enamel!
Bucket
Always have a bucket on hand, with a little water in it. You can throw things back into it and plus, the paint won't dry up.
HOW TO SET UP AND PREPARE FOR SPRAY PAINTING
STEP 1
Screw the hose into the turbine and turn the turbine on. Then, let the air go through the hose to clean out any debris.
STEP 2
Next, connect the hose to the spray gun and stand 20 feet away from where you are spraying. If you are too close to the surface, you will suck in the paint, dust and dirt.
STEP 3
Set up a spray booth, using back sheets and drop sheets.
STEP 4
Thin the paint by 10% to avoid the stipple effect. For a 1L tin of paint, add 100 mL of water to it in a 1L pot.
Shake the litre pot, then put the lid on it, twisting it tightly. Always mix the paint in a clean pot or bucket as the gravity gun does not have a filter.
STEP 5
Before you begin spray painting, wear a P2 mask and safety glasses. Then, spray the gravity gun in a steady side-to-side motion, keeping it straight to the panel. You can also choose to spray the gun up and down the top surface of your furniture.
Daryl recommends applying a tact coat of paint first and then applying a wet coat straight after.
HOW TO CLEAN THE HOSE AND SPRAY GUN
STEP 1
Fill the pressure pot up with warm, soapy water, reattach it then give it a shake to get the residue out. Tip the residue into the waste bucket.
STEP 2
Then, connect the hose to the turbine and spray it a few times.
STEP 3
Using a soft toothbrush, clean the spray gun with warm soapy water. Pull the needle out and also clean it. Release the pressure of the spray gun.
Comments